Intelligent control system first brand

Global 100 enterprises designated suppliers

Welcome to Shenzhen Chenjie Electron Co., Ltd. official website!

Service Hotline

+86-755-26518500

辰杰电子Chenjie Electron

Hot Keywords:  High power remote control, Wireless Controller, Wireless receiver module

Product Categories
0.6mA low current high rate superheterodyne CHJ-801
    Publish time 2017-06-02 10:49    
0.6mA low current high rate superheterodyne CHJ-801
Superheterodyne 801 is VHF / UHF UHF wireless data transmission high quality superheterodyne receiver module. The module is based on market feedback and the recommendations of the majority of users, and the introduction of highly shocking products. The module uses the European plant ultra-high frequency, low noise large scale integrated circuit, with a high cost, a comprehensive anti- , High reliability, can be FCC, CE indicators. Rolling code remote control / electric gating system and long-distance transmission of the preferred products. Large number of remote control garage doors, retractable doors, barrier, etc .; for GSM / GPS car System support; industrial control, communications and security and other fields; the receiving system is used in complex environments require a higher system ideal.
Features are as follows:
(1) the sensitivity of up to -110dbm, the receiving distance of more than twice the ordinary receiver board.
(2) a reasonable reception bandwidth, with a strong ability to suppress the same frequency, anti-interference ability to adapt to a variety of environments.
(3) good dispersion of radiation suppression, easy to pass FCC, CE testing standards.
(4) good shielding, a variety of installation environment on the module performance is small, good consistency.
(5) good local oscillator radiation suppression capability, multiple modules can work together (single and more) and will not interfere with each other, does not affect the receiving distance.
(6) using SAW local oscillator, stable performance, suitable for a wide temperature range.
(7) for 250-450MHz frequency adjustment is easy, short supply cycle.
(8) single-chip direct interface, easy to achieve (transmission rate up to 20kbps).
(9) to enhance the anti-interference ability of the phone / to improve the decoding waveform.
 
Electrical parameters: VOD-VSS-5V, TA = 25 degrees

Parameters
symbol
State
              Reference
Unit
Minimal
standard
maximum
working frequency
Fc
  
433.92
 MHz
Modulation mode
  
                  ASK
 
Receiving sensitivity
 
50 ohm antenna directly input BER3 / 1000,1.2kbps
-105
 -110
 -115
Dbm
Maximum input unsaturated power
  
    -10
    0
Dbm
Receive bandwidth
  
± 120
 
± 1000
KHz
Receive on time
Ton
 
 
 
    10
Ms
Power consumption
IRC
RX-EN = LOW
 
      6
MA
Decode output high voltage
  
   4.5
 
 
V
Decode output low voltage
  
    0.5
V
Operating temperature
TC
 
-40
 
85

801 is the wireless receiver module using ASK transmission mode, ASK way in the transmission will produce data signal pulse width of the change, therefore, in the preparation of wireless data corresponding to this action: for example, the following agreement.
  "1" to receive decoding when the high level is less than 500 us can be judged as "1"
                
 
          750us 250us
"0" high level greater than 500us can be judged as "0"
                   
          250us 750us
                                       The boot code can be "1" or "0" code, the starting code with 2ms low.
 
 Limit rating table:

parameter
symbol
Value
unit
DC supply voltage
Vcc-Vss
6.5
V
Workpiece temperature range
TOPR
-40to85
degree
Storage temperature range
TSTG
-60to125
degree
Pin Description:


Feet
name
                Function Description
1
  ANT
Antenna access point
2,3
GND
Grounded
4
  RX-DATA
Decode square wave output
5
VCC
Module power supply
Application Note:
(1) VCC supply voltage and module operating voltage, error ± 5%.
(2) (3) (5) between the feet near the next one porcelain 0.01uF capacitor.
(L1 = L2 = 100Uh), (C1, C2 = 0.1uF), reduce the interference of the system to the module, if the module access to the system has a large interference or too high requirements,
If the system interference is not large or not too high requirements, L1, L2, C2 may not.
(4) antenna on the module to receive a great impact, it is best to connect a quarter-wavelength single-oscillator antenna.
(5) Antenna position on the module to receive the effect is also affected, you can put the antenna directly ANT interface, can also be connected through the ANT pin system and then receive the antenna,
The antenna is as straight as possible, away from the shield, the high pressure, and the source of the interference.